Installation and Debugging Procedure for Pipe Pressing Machines

During the installation and commissioning of a pipe-pressing machine, there are many details that require attention. The key points to note when using a pipe-pressing machine include handling, installation, the use of a micrometer, pressure adjustment, oil lubrication, electrical connection, and adjustment of the die-opening speed.

1. Handling: The pipe pressing machine should be handled using a forklift, with the force applied to the bottom of the machine. It is strictly prohibited to invert the pipe pressing machine. It is also strictly forbidden to lift or carry the machine by its head, motor, or electrical control box.

2. Installation: The pipe press must be placed horizontally. High-quality cable crimping machine On a solid foundation and with proper grounding.

3 Micrometer: Used to adjust the amount of contraction in the crimped hose. Turning it counterclockwise by half a turn increases the compression by 1 mm; turning it clockwise by half a turn decreases the compression by 1 mm.

4. Pressure Adjustment: The system pressure of the pipe-bending machine is 31.5 MPa, and it is adjusted via the relief valve. Turning the adjustment knob clockwise increases the pressure, while turning it counterclockwise decreases the pressure (the pressure has already been set at the factory; adjustments can be made independently if necessary). Wuzhou Hydraulics: Precautions for Installation and Commissioning of Pipe-Bending Machines

5. Oil Filling: Open the oil tank cap and add #46 hydraulic oil to the oil level gauge up to the 2/3 mark.

6. Power Connection: Connect the power cord to the power source specified for the tube-pressing machine, then start the motor and observe its rotation direction. The motor’s rotation direction should be consistent with the direction indicated on the motor itself. Wuzhou Hydraulic: Installation and Debugging Precautions for Tube-Pressing Machines—If the motor’s rotation direction does not match the indicated direction, please swap the positions of any two of the power supply wires.

7. Adjustment of mold opening speed: The speed of mold opening—whether fast or slow—is controlled by the flow divider valve, adjusted clockwise.