PT150-FF Fast-Charging Pressure Testing Machine

The equipment is specially designed for pressure testing of workpieces. It is equipped with a high-pressure liquid generation unit and a high-pressure liquid pressure control system. The equipment can generate high-pressure liquids up to a maximum of 1300 bar. To enhance the efficiency of pressure testing and extend the service life of the boosting pump, this machine is designed and fitted with two parallel high-pressure pumps and a rapid filling circuit.

• Fluid medium: First, add tap water to the tank, then add approximately three liters of rust-inhibiting additive.
• Drive: Before the test, compressed air at 7 bar must be connected.
• When performing the hydrostatic test, one end of the hose assembly must be connected to the transition fitting on the manifold via a suitable adapter, while the other end of the hose assembly can be sealed off with a plug.
• Before applying pressure, be sure to first start the rapid-fill pump to expel the air from the hose. Once water free of bubbles starts flowing out from the other end, then tighten the plug.
• When performing suppression, it is strictly prohibited to open the cabinet door for operation.
• Warning: This device must not be used for blasting tests under any circumstances!!!